Message
If you have any questions, please contact us, and we will get back to you as soon as possible.
◉ Product Description
3030 Aluminum Profile Selection: Three Factors—Load Capacity, Slot Closure, and Slot System
Shanghai Xiangda Industrial Aluminum Profile Co., Ltd. | Cross-section: 30×30mm | Slot width: 8mm (for M8 ball spring nuts) | Material: 6063-T5 | Silver-white anodized finish | 6-meter lengths, can be cut to size
3030 profiles are well stocked across the full range. Cutting, drilling, tapping, and complete frame assembly are available.
Load capacity reference: The reference load is the allowable load (kgf) for a single profile under the following conditions: a 500mm span, simply supported at both ends, a concentrated load at the center, and deflection limited to 1/1000 of the span.The actual load capacity of a complete frame must be calculated based on the load borne by each profile, the number of profiles, and the structural design. The figures in the table above should not be used directly as a load rating for the entire frame. As the span increases, load capacity decreases in proportion to the span (at a 1000mm span, it drops to approximately 9–12kg per profile).
3030 Industrial Aluminum Profile: Full-Range Specifications Table
Frequently Asked Questions About 3030 Aluminum Profiles
What is the load capacity of a 3030 aluminum profile? A single profile can support an allowable load of 36–48kg at a 500mm span, decreasing to 9–12kg at a 1000mm span. The conditions are simply supported at both ends, a concentrated load at the center, and deflection limited to 1/1000 of the span. The capacity of a complete frame must be calculated based on the number of profiles and the structural design.
How do I choose between 3030 and 4040? Under the same test conditions, the load capacity of a single 3030 profile is approximately one-quarter that of a 4040 (3030: 36–48kg; 4040: 100–200kg). Choose 4040 for spans exceeding 800mm or for heavier equipment.
Ready stock supply
Ample inventory of aluminum profiles and accessories, ready to ship upon order
Processing according to drawings
With many years of design and processing expertise, we meet customers' high-standard requirements
Mold custom fabrication
Custom fabrication by quantity to meet personalized needs, one-stop precision production
Processing Services
End-face tapped hole
Handle hole
Countersunk hole
Built-in hole
Built-in internal hole
Precision cutting for professional equipment
After surface polishing treatment, the cut marks are burr-free. Cutting precision: positive/negative 0.2, verticality: 0.1°
◉ Production and Warehousing
◉ Message
◉ Related Product Recommendations

Thank you very much for writing to us. Please leave your message and contact information, we will reply to you within 24 hours.






